Wireless Communication Library Support Forum
Frameworks => Bluetooth Framework => Topic started by: mvreza on December 29, 2010, 04:15:21 PM
-
Hi,
I use wclClient to connect a discovered device by wclBluetoothDiscovery, but when doing it, client device request passkey (authentication) to connect my app. Passkey requesting in my app side disabled by set authentication property to False in wclClient.
so, how to disable passkey requesting in client device?
thanks :)
-
Hi,
I think it is better to check device's manual where that should be described.
-
In TextBlue software, in "Send To Device" form, you are implement my opinion, when TextBlue sending file to a device, device not requsting any passkey.
Which one of WCL component uses in "Send To Device" form and how?
thanks.
-
You mean using OPP profile? TB uses wclOPPClient but it doesn't disable any PIN request. It appears so because OPP profile usualy doesn't require PIN. But some device may require for PIN even for OPP profile.
-
Hi,
I am tested wclOPPClient, and it was my opinion in sending file without requesting authentication in client device. thanks.
Can I simulate proximeter sender with wclBluetoothDiscovery and wclOPPClient, in other words
is it possible implement discovers devices with wclBluetoothDiscovery when sending file to discovered device with wclOPPClient (concurrency) and conversely?
thanks a lot :)
-
Hi,
Yes of course. wclProximitySender uses wclOPPClients and wclBluetoothDiscovery internaly.
Yes, you can, but it is not good idea.
-
Hi,
I went to connect 2 device with one wclOPPClient, but it is impossible.
For this idea, must create one wclOPPClient component for per connection in run time?
thanks. :)
-
You must use one wclOPPClient to connect to one device. If you want connect to more than 1 device you must use more than 1 wclOPPClient: one per device.