Wireless Communication Library Support Forum
Common => Common => Topic started by: pbaker21 on March 31, 2016, 02:20:30 PM
-
Hi,
I'm not sure if this is an appropriate question for this forum.
I
-
Hi,
What would you like to ask?
-
Hi,
I'm not sure if this is an appropriate question for this forum.
I'm desperate to be able to communicate with a 'Bluetooth Bracelet', in particular the 'Wireless Buzzband BT-88' or the 'Xiaomi Mi Band' using the HM-10 bluetooth module (via an Arduino)
I'm sure this must be possible, if so, can anyone help with coding advice?
Many thanks,
Paul
-
There is nothing hard. The Bt-88 is BLE device so check which services it supports. Then refer to services docs and set required characteristic value to vibrate it.
-
Hi,
If only it was that easy! I have tried to find out all I can, with any luck, hence joining a forum.
Regards,
Paul
-
Hi,
Well. This forum is for WCL support but if you would like you can e-mail me to mike@btframework.com (or to btframework@gmail.com) with your problem details and I will try to help.
-
Hi,
Many thanks - what would be very helpful is knowing:
1. what the default frequency of the Bracelet are
2. what to send in regards to telling the device to buzz, so, do I send the word "buzz" or "BUZZ" or "VIBRATE" ...so on
3. do I need to know the devices MAC_ADDRESS? If so, how do I find this out?
4. can I assume the sent commands (to the Bracelet) are all AT Commands?
Regards,
Paul
-
1. what the default frequency of the Bracelet are
Can be found in bracelete docs.
2. what to send in regards to telling the device to buzz, so, do I send the word "buzz" or "BUZZ" or "VIBRATE" ...so on
As it is BLE device you must write characteristic value, not sending any words.
3. do I need to know the devices MAC_ADDRESS? If so, how do I find this out?
Yes of course. In common way you have to send HCI INQUIRY command. For AT command based BT module refer to its docs.
4. can I assume the sent commands (to the Bracelet) are all AT Commands?
No. It is binary GATT protocol.